| Table of Contents |
|---|
...
Location of Well Foundation Parameters Dialog
Ribbon menu Analysis and Design tab Design Parameters title under well foundation parameters by clicking on the command Well Foundation Parameters can be found in the dialogue.
...
Well Foundation Parameters
It determines with parameters which criteria the program will comply with in concrete design and rebar placement stage.
...
Specifications |
|---|
Concrete cover  It is the distance from the center of gravity of the reinforcement to the outer face of the concrete. |
Rollover safety factor  Give the overturning safety coefficients according to seismic and non-earthquake conditions. |
Slip safety factor  Give the slip safety coefficients according to seismic and non-earthquake conditions. |
Migration safety factor  Give the safety factor for the migration. |
Min. tensile reinforcement pursuit  In the tensile zone, give the minimum percentage value to be used in the reinforcement calculation. The entered value is multiplied by the cross-sectional area and the reinforcement selection is made in a way that is not less than the result. |
Min. tensile reinforcement range  In the tensile zone, give the smallest possible distance between two reinforcement bars. This value is taken into consideration in the selection of reinforcement. |
Max. tensile reinforcement range  In the tensile zone, give the value of the greatest possible distance between two rebars. This value is taken into consideration in the selection of reinforcement. |
Min. transverse reinforcement pursuit  Give the minimum percentage value to be used in horizontal reinforcements. The entered value is multiplied by the cross-sectional area and the reinforcement selection is made in a way that is not less than the result. |
Min. transverse reinforcement range  Give the smallest possible distance between two reinforcement bars to be used in horizontal reinforcements. This value is taken into consideration in the selection of reinforcement. |
Max. transverse reinforcement pursuit  Give the maximum possible distance between two reinforcement bars to be used in horizontal reinforcements. This value is taken into consideration in the selection of reinforcement. |
Min. pressure reinforcement pursuit  In the pressure zone, give the minimum percentage value to be used in reinforcement calculation. The entered value is multiplied by the cross-sectional area and the reinforcement selection is made in a way that is not less than the result. |
Min. pressure reinforcement range  Give the smallest possible distance between two reinforcing bars in the pressure zone. This value is taken into consideration in the selection of reinforcement. |
Max. Press. range of reinforcement  Give the maximum possible distance between two reinforcing bars in the pressure zone. This value is taken into consideration in the selection of reinforcement. |