...
The table below contains the sub layers that are closed and opened in the drawing details tab in the layer settings dialog.
Closed layers | Drop down layers |
Column IDColumn plaster | |
Column dimensioning | |
Column support ID |
|
Column support size |
|
Beam pattern | |
Beam ID |
|
Beam dimensioning |
|
Shearwall pattern |
|
Shearwall ID | |
Shearwall size |
|
Coupling beam dimensioning |
|
Strip footing ID | |
Strip footing size |
|
Single footing ID |
|
Single footing dimensioning | |
Pool wall ID | |
Pool cantilever slab ID | |
Pool surface ID | |
Drop down layers | |
Column plaster |
The table below shows the initial state of a project saved in the structural program, when it was opened in the architectural program, and its state after the architecture was applied.
Before Make Compatible With Architecturemake compatible with architecture |
 |
After Make Compatible With Architecturemake compatible with architecture |
 |
Make Compatible With Structural
...
The table below contains the layers that are closed in the layer settings dialog and the sub layers that are closed and opened in the drawing details tab.
Closed layers | ||||
Terrain | ||||
Roof | ||||
Roof hole | ||||
Roof plane | ||||
Wall | ||||
Shearwall | ||||
Light/Camera | ||||
Door/Window | ||||
Railing | ||||
Zone | ||||
Zone hole | ||||
Zone edge | ||||
Sweep | ||||
Jamb | ||||
3D geometric object | ||||
Exterior veneer | ||||
Closed sub-layers | ||||
Column plaster | ||||
Drop down layers | Terrain | Column plaster|||
Column ID | ||||
Roof |
| Column dimensioningRoof hole | ||
| Column support ID | |||
Roof plane |
| Column support size | ||
Wall |
| Beam patternShearwall | ||
| Beam ID | |||
Light/Camera |
| Beam dimensioningDoor/Window | ||
| Shearwall hatch | |||
Railing |
| Shearwall ID | Zone |
|
Shearwall sizeZone hole | ||||
| Coupling beam dimensioning | Zone edge |
| |
Strip footing ID | ||||
Sweep |
| Strip footing size | ||
Jamb |
| Single footing ID | ||
3D geometric object |
| Single footing dimensioning | ||
Exterior veneer |
| Pool wall ID | ||
| Pool cantilever slab ID | |||
|
| Pool surface ID |
In the following table, the initial state of a project saved in the architectural program when it was opened in the structural program and the after the make compatible with structural was applied.
Before Make Compatible With Structuralmake compatible with structural |
 |
After Make Compatible With Structuralmake compatible with structural |
 |