...
Continuous Beam Connection Settings Dialog
...
Flange Connection Type
...
In this tab, it is determined whether the top flange connection will be, welded or bolted. Check the relevant option.
...
Plates Tab
...
Give the plate thickness and length.
...
Select options based on the schematic figure given. After the selection process, you can instantly view the changes in the 3D view.
Shear Plate Tab
...
Give the plate dimensions according to the given schematic figure.
...
Top Left/Top Right Notch Tab
...
Select options and enter values according to the given schematic figure.
...
Welds Tab
...
The weld properties of the connections given in the schematic representation are set in the Welds tab. Give the size, type, angle values and mark the option whether to weld under construction site conditions.
...
Top Left Flange Bolts Tab
...
Determine the count of bolts and the distances between bolts according to the schematic representation given.
...
Top Right Flange Bolts Tab
...
Determine the count of bolts and the distances between bolts according to the schematic representation given.
...
Bottom Left Flange Bolts Tab
...
Determine the count of bolts and the distances between bolts according to the schematic representation given.
...
Bottom Right Flange Bolts Tab
...
Determine the count of bolts and the distances between bolts according to the schematic representation given.
Bolt properties: Bolt grade, bolt size and hole properties are set in bolt properties.
...
Assembly Plate Tab
...
The geometry of the plate used is given or one of the L profiles in the library can be used as a connection element with the Use Section option. If you check the plate geometry option, enter the plate dimensions according to the schematic representation.
...