You can use Analysis+Design with appropriate design parameters by opening the Analyze and Design.cde project file, which has the structural system and load model properly arranged.m |
|
...
Select the select Seismic Forces Calculation Method as the Mode Combination Method Using Response Spectrum.
From Basement Calculation Method Using Modal Analysis section, select Separate Analysis for basements.
Select Use Semi Rigid Diaphragmsfrom the Slab Diaphragms Modelling Method section.
Click the OK button to close the dialog.
Click the Analysis and Design tab in the ribbon menu.
Open the Concrete list from the Design Parameterssectionheading.
...
Click the General Concrete Reinforcement Parameters command from the Concrete list .
General Concrete Reinforcement Settingswindow dialog will open.
...
Check the concrete parameters.
Click the OK button to close the dialog.
Click the Column Parameters command from the Concrete list .
The Column Parameters dialog will open.
...
Check the slab parameters.
Click the OK button to close the dialog.
Click the Steel command in the ribbon menu Analysis and Design tab, Design Parameters section heading.
...
The Steel Design Optionsdialog will open.
...
The Steel Selectiondialog will open.
Click the Column tab.
...
Check the column longitudinal and transverse rebar diameters to be used in the column designreinforcement diameters.
Click the Beam-Coupling Beam tab.
Check the beam longitudinal and transverse rebar diameters to be used in the beam designreinforcement diameters.
Click the OK button to close the dialog.
Click the Analysis+Design (F9) command.
...
Click the Yes button.
Wait for the analysis to complete in theAnalysis Status window.
After the analysis is complete, click the OK button to close the window.
...