Page Comparison

...

• Click on the Concrete/Project Settings/Story Settings icon in the ribbon menu.

• Stories dialog appears. The project name shown here should not be confused with the file name where the project is stored. It has nothing to do with the project file name given when saving the project. Project Settings

• When the Add Above button is clicked with the left mouse button, a story is added on the selected story.

• If the Add Below button is clicked, a story is added under the active story. In this way, the project can be opened as many stories as desired.

• The story height of the newly added stories can be defined in the "New story height" section. When "Default height" is checked, the height of the opened story is taken as the value that can be defined next to the default height line. If the line "Same as last story" is marked, the height of the opened story is taken to be the same as the last story opened.

• In order to delete an existing story, the relevant story line is selected by clicking the left button of the mouse and the Delete button is clicked. “You cannot cancel this process. Do you want to continue? ” warning comes. If the question is confirmed, the selected story is deleted. Care should be taken when wiping stories. Because if there are data entered on the deleted story, these data will be deleted together with the story. This process is irreversible. The master story(zero numbered story) cannot be deleted.

• Clicking the OK button will exit the dialog.

...

In the program, the story base is called "Architectural Plan Mode" and the story ceiling is called "Structural Plan Mode". Objects on the story can be entered in the architectural plan mode. It is not possible to enter these objects in pattern layout mode. The opposite is true for story ceiling objects. Objects such as columns, axes and lines can be entered in both drawing modes. In Architectural Plan Mode, click the View/Mode/ Structural Design Mode icon in the ribbon menu to switch to Structural Plan Mode . This can also be done by pressing Shift + Tab on the keyboard.See also:

...