...
How does ideCAD scale design values of combined response according to ASCE 7-16?
...
| Tip |
|---|
|
| Notetip |
|---|
|
...
Symbols
V = The equivalent lateral force procedure base shear
Vt = The base shear from the required modal combination
Cs = The seismic response coefficient
W = The effective seismic weight
R = The response modification factor in Table 12.2-1
Ie = The Importance Factor
SD1 = the design spectral response acceleration parameter at a period of 1.0 s
T = The fundamental period of the structure(s)
...
A base shear (V) shall be is calculated in each of the two orthogonal horizontal directions using the calculated fundamental period of the structure T in each direction and the procedures of Section 12.8.
The seismic base shear, V, in the earthquake direction considered, is determined by the following equation.
| Mathinline | ||
|---|---|---|
|
Scaling of Forces per ASCE 12.9.1.4.1
...
Where If the calculated fundamental period exceeds CuTa in a given direction, CuTa shall be is used in lieu of T in that direction. Where the combined response for the modal base shear (Vt) is less than 100% of the calculated base shear (V) using the equivalent lateral force procedure, the forces shall be is multiplied by V∕Vt where
V = the equivalent lateral force procedure base shear, calculated in accordance with this section and Section 12.8, and
Vt = the base shear from the required modal combination.
Scaling of Drifts per ASCE 12.9.1.4.2
...
Where If the combined response for the modal base shear (Vt) is less than CsW, and where Cs is determined in accordance with Eq. (12.8-6), drifts shall be are multiplied by CsW∕Vt.
| Mathinline |
|---|
| Warning |
|---|
TBDY 'den farklı olarak kuvvetler ve göreli öteleme aynı oranda arttırılmıyor. Her ikisi içinde otomatik hesap yapılmalı ve belirlenen katsayılar ile arttırılmalıdır. |
Topics covered in this section:
...
|
...
| Child pages (Children Display) |
|---|
...
Related Topics