You can review the design results of reinforced concrete elements in the Review Concrete Design |
project with Analysis+Design. |
|
|
Click Structural Inspection tab in the ribbon menu.
From the Output sectionheading, open the Concrete All Failures list.
Click the As(-) Concrete Insufficient Rebar Area command.
...
The results of the lack of reinforcement space Reinforcement insufficiency results will appear in the visualization window.
...
From Visualization dialog, select All Failures from the Design Output list.
Failure situations are seen in the column design results.
It means that there is no failure insufficiency in the green colored elements, and there is a failure an insufficiency in the red colored elements.
Select the Longitudinal rebar pursantage (%-Columns) from the design output Concrete list.
The longitudinal reinforcement ratios used in the column concrete design are shown.
...
Close the visualization dialog .
Click the Reinforced Concrete tab in the ribbon menu.
Open the Concrete list in the Design section heading.
Click on the colon column command.
The Column Reinforcement dialog opens.
...
Click the Forces-Reinforcement Areas tab.
The internal force values used in the column design are listed.
Calculated-required-existingreinforcement areas and column design are examined.
Column design internal forces are examined.
...
Click the Capacity Diagrams tab.
Calculated axial force and biaxial bending interaction curve are given.
...
Click the Moment-Curvature tab.
Activate the Caltrans idealized model.
Activate the stop when a fiber reaches ultimate stress.
The results of the Moment- Curvatureanalysis results calculated using the fiber cross section fibers appear.
...
Click the OK button to close the dialog.
Open the Concrete list from in the Ribbon menu Design section heading.
Click the Beam command.
The Beam Reinforcement dialog opens.
...
Click the Reinforcement Areas tab.
Calculated-required-existing-differencereinforcement areas of the concrete beam are displayed.
...
Click the Deflection & Crackings tab.
Concrete beam deflection and crack control calculation is visible.
...
Click the OK button to close the dialog.
Open the Concrete list from in the Ribbon menu Design section heading.
Click the Slab command.
...
The Slab Reinforcement dialog opens.
...
In the Slabs tab, the reinforcements determined as a result of the slab design slab reinforcements are listed.
Click the OK button to close the dialog.
...
Follow the steps of the video below.
| Widget Connector | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Next Tutorial