...
You can create Window 1 is created by following the steps below.
| Table of Contents |
|---|
Planning on Paper
Before making a window or door, it would be helpful to plan it on paper. In this way, while the sizing process becomes easier, the possibility of making mistakes will be reduced.
...
You need to make the Dio Design Settings for all DIOs correctly because all Dios are sized with these settings in the ideCAD Architecture program. You can also do this process after the window is finished, but it will be useful to finish this process before starting the design in order not to make sizing errors during the design.
...
Click on the Line Drawing / Gap Polygon .
Go around your case with the space polygon, referring to the outer nodes of the case.
The gap polygon will close when you connect the last point with the first point.
...
Creating Material and Covering the Window with This Material
...
Later, you can make any changes you want in 2 dimensions in plan, section and views and detail them.
...
Next Topic