Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

With the General Sweep Settings command, the alignment type, elevation, material and drawing settings of the profile object can be accessed.

Location of the General Sweep Settings Command

...

Sweep

Measure

Listed

Explanation

Constant

Independent

It means that the length measure found while defining the material will be used exactly as the length value.

Length

Independent

It means that the length measure found while defining the material will be used exactly as the length value.

Length

It means that the length of the material will be found by multiplying the length measure found when defining the material and the length of the sweep.

Area

Independent

It means that the area measure found while defining the material will be used exactly as the amount.

Outside area

It means that the area measure found while defining the material will be used by multiplying it with the sweep outside area.

Volume

Independent

The volume measure found when defining the material will be used exactly as the volume of the material.

Volume

It means that the volume measure found when defining the material will be used by multiplying the sweep volume.

Count

Independent

The count measure found while defining the material will be used exactly as the material number.

Count

It means that the number measure found when defining the material will be multiplied by the number of sweeps

...