...
After the analysis is done, you can access it by clicking the Beam command under the Steel Design heading in the ribbon menu Analysis and Design tab .
...
Steel Beams
...
Specifications |
---|
ID It is the name of the steel beam in the plan. |
Section It is the section used in steel beam. |
Material It is the material used in steel beam. |
PMM Ratio It is the ratio of requirement to section capacity (PMM Ratio = Need/Capacity). |
Combo It is the load combination that produces the most unfavorable PMM ratio. |
Maj-Shr-Ratio It is the ratio of the shear force in the major direction of the section to the capacity in the major direction. |
Combo It is the load combination that produces the most unfavorable stress ratio in the major direction. |
Min-Shr-Ratio It is the ratio of the shear force in the minor direction of the section to the capacity in the minor direction. |
Combo It is the load combination that produces the most negative stress ratio in the minor direction. |
Strength check It is an information box whose sign changes according to the presence or absence of negativity in the section. |
Deflection It is the deflection value made by the steel beam. |
Limit value It is the value of the maximum allowed deflection of the element calculated according to the limit value determined from the design tab of the steel beam settings. |
Deflection check It is an information box whose sign changes depending on whether the deflection limit is exceeded or not. |
Slenderness It is the slenderness value of the steel beam. |
Limit Value It is the maximum slenderness value allowed in the steel beam. |
Details Design details are shown in detail. |
Previous The cursor moves to the previous line. |
Next The cursor goes to the next line. |
OK It saves the changes made and closes the dialog. |
Cancel Closes the dialog without saving the changes made. |
Summary Information The summary information about the line where the cursor is located is given in the name of the dialog in story, pose format. For example BASE STORY, SB001 |
Using the Shift key In this tab, you can select more than one row with the Shift key, enter a value by double-clicking any cell whose value is open to change, and make that value apply to all selected rows. |
Using the Ctrl key Ctrl key selects the lines in between one by one. |
Design Details
...
Specifications |
---|
Schematic drawing |
Section properties It is the part where the name and geometric properties of the section take place. |
Material properties The properties of the steel material used in the section are listed. |
Forces and moments Internal forces occurring in the element, belonging to the selected load combination, are shown in this section. |
Combo The load combination is selected. |
Demand/capacity ratio The demand/capacity ratio in the section of the selected load combination is displayed. |
Shear check The shear capacity ratio of the steel beam is shown. |
Axial force and biaxial bending control The axial capacity and moment capacity ratios of the steel beam are shown. |
Design factors K factor: It is the effective length coefficient used in calculations. |
...
Next Topic
...