Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

With the Curve Beam command, you can define a curve beam between each point you click with the mouse. You can define curve beams or beams by clicking the intended points between the columns.

Location of Curve Beam Command

You can access it under the ribbon menu, Concrete tab , under the Concrete heading.

Usage Steps

  • Click the Curve Beam icon.

  • Determine the starting point of your curve beam by clicking a column.

  • Move the cursor to give your intended form-fitting curve and click the left button again.

  • Click another point in the same way if the curve form is to be continued.

  • As you identify the points, your curve beam will take shape according to the position of the points.

  • Finally, click on the column to which the curve beam will be attached.

  • End the command by clicking the right mouse button.

  • Your curve beam will form.

  • Exit the command by pressing the Esc key on the keyboard.

Usage step

Columns between which curve beams will be drawn

Determining the starting point of the beam

Determination of the second point

Determining the third point

Determining the point where the curve beam will end

Formation of curve beam


  • No labels