When creating ribbed or waffle slab, it is important which type of rib will be considered as ribbed or waffle tooth. You can use the Set Typical Rib command for this operation .
Location of Set Typical Rib Command
You can reach it under the Concrete tab in the ribbon menu under the Concrete heading.
Usage Steps
Click the Set Typical Rib icon.
Select two rib to identify typical rib in ribbed slab.
If you want to define a single typical rib, you can double-click on the same rib.
If you want to define a single typical tooth in waffle slab, select the rib tooth in the intended direction.
If you want to specify a typical rib in both directions, click on the intersection of the rib you want to appear as a typical rib.
Your typical rib will be determined.
Usage step |
|---|
Ribbed slab before the typical rib appears  |
Identification of the first typical rib  |
Determination of the second typical rib  |
Ribbed slab after setting typical rib  |
Waffle slab before the typical rib appears  |
Typical rib determination in two directions  |
Waffle slab after setting typical ribs  |