...
It can also be accessed by clicking the Objects/Roof/Vault/Vault Settings icon.
...
General
...
Tab
...
Specifications | ExplainedDescription |
|---|---|
VaultnameID  | The name of the vault is entered. |
Number of pieces Chord count | When creating arc or curvilinear vaults, it is entered in how many pieces they will be formed. As the number count of pieces increases, the vault lines get rounded. |
KotElevation  | The level of the lowest point of the vault is entered from the floor story floor. |
Thickness  | The thickness of the vault coating is entered. |
Custom Costum size  | If this option is selected, vault width and vault height can be entered in the information boxes on the right. |
Original size  | If this option is checked, the line, arc, etc. selected for the vault section. the dimensions of the objects are used. |
Direction  | It is selected by clicking one of the right or left options. It is determined whether the thickness of the vault (in the Z direction) will be inward or outward. If left is selected, the thickness is given outward, if right is selected, it is given inward. |
spleenDelta  | The deviation alignment of the vault in the plan is selected. Right, middle and left options determine where the vault axis will pass (where the vault will be defined). It refers to the vault defined from the upper right according to the viewing direction, defined in the middle and defined from the lower left. The nodes at the ends of the vault defined from below are located at the lower corners, and the upper corners defined from the top. The nodal points of the vault defined from the middle are located in the middle of the vault end edges. |
Fringe Edge type  | The eaves geometry edge type of the vault eave is determined. |
textures
...
Specifications | Explained |
|---|---|
Materiel | The material to be covered in the solid model of the vault is selected. The vault is covered with the selected material and displayed in the solid model as such. |
Line Type | Line type of the line forming the vault is selected in the plan. Clicking the down arrow buttons to the right of the boxes opens the list of line types. From this list, the desired line type is selected by clicking the left mouse button. |
...