Vault Settings
- Zeynep Aladağ
- Hakan Şahin
With the Vault Settings command, settings such as chord count, elevation, height, drawing, material selection, structural material can be accessed.
Location of Vault Settings Dialog
Vault, which appears after the Vault command is run, is also available in the auxiliary toolbar.
In the Architectural Program
You can access under the ribbon menu Drawings tab, Text title.
In Structural Program
You can access under the ribbon menu, Drawings tab, Text title.
General Tab
Specifications |
|---|
Vault ID The name of the vault is entered. |
Chord count When creating arc or curvilinear vaults, it is entered in how many pieces they will be formed. As the count of pieces increases, the vault lines get rounded. |
Elevation The level of the lowest point of the vault is entered from the story floor. |
Thickness The thickness of the vault coating is entered. |
Costum size If this option is selected, vault width and vault height can be entered in the information boxes on the right. |
Original size If this option is checked, the line, arc, etc. selected for the vault section. the dimensions of the objects are used. |
Direction It is selected by clicking one of the right or left options. It is determined whether the thickness of the vault (in the Z direction) will be inward or outward. If left is selected, the thickness is given outward, if right is selected, it is given inward. |
Delta The alignment of the vault in the plan is selected. Right, middle and left options determine where the vault axis will pass (where the vault will be defined). It refers to the vault defined from the upper right according to the viewing direction, defined in the middle and defined from the lower left. The nodes at the ends of the vault defined from below are located at the lower corners, and the upper corners defined from the top. The nodal points of the vault defined from the middle are located in the middle of the vault end edges. |
Edge type The edge type of the vault eave is determined. |