This combination connection is a steel beam - secondary steel beam combinationconnection . After the beams are defined;
With quick drawing mode turned on;
From the Steel Connection menu, click on the line Rigidized Face Plate JointStiffened End Plate Connection icon.
In 3D perspective view, move the mouse pointer closer to the element, close to the support
After this process, the virtual image of the combination connection will appear.
If the combination connection is suitable, create the combination connection by clicking the left mouse button.
The combination connection will occur with default settings.
Quick drawing mode is off;
From the Steel Connection menu, click on the line Rigidized Face Plate JointStiffened End Plate Connection icon.
Click the column then the beam before the 3D perspective view.
The combination connection will occur with default settings.
Double-click the combination connection to change settings. The unification connection dialog will open.
...
| Table of Contents |
|---|
...
General
...
Tab
Give the values according to the schematic figure given.
...
...
Stiffener Tab
...
If a reinforcement stiffener plate is to be created, check the Back reinforcement back stiffener plate option and give the plate thickness.
...
...
Chamfers Tab
For easy assembly of the plates in the field, the use of slope, slope type and geometric properties are determined in the joint connection settings dialog.
...
Bolts Tab
Set the number count of bolts and spacing according to the schematic figure given.
...
Bolt properties: Bolt classgrade, bolt diameter size and hole properties are set in bolt properties.
...
Welds Tab
The source weld properties of the joints connections given in the schematic representation are set in the Resources Welds tab. Give the thicknesssize, type, angle values and mark the option whether to weld under construction site conditions.
...
Welding geometry is determined automatically by the program. These properties can be changed to easily determine the joint connection properties. Geometry features are in accordance with industry standards and in the form specified in AISC.
...
Welding Electrode:
In this section, the strengths of the welding electrodes are defined.
...