This combination is a steel beam - secondary steel beam combination. After the beams are defined;
With quick drawing mode turned on;
From the Steel menu, click on the line Rigidized Face Plate Joint.
In 3D perspective view, move the mouse pointer closer to the element, close to the support
After this process, the virtual image of the combination will appear.
If the combination is suitable, create the combination by clicking the left mouse button.
The combination will occur with default settings.
Quick drawing mode is off;
From the Steel menu, click on the line Rigidized Face Plate Joint.
Click the column then the beam before the 3D perspective view.
The combination will occur with default settings.
Double-click the combination to change settings. The unification dialog will open.
General Settings Tab
Give the values according to the schematic figure given.
Berkitme Tab
If a reinforcement plate is to be created, check the Back reinforcement plate option and give the plate thickness.
Cuts Tab
For easy assembly of the plates in the field, the use of slope, slope type and geometric properties are determined in the joint settings dialog.
Bolts Tab
Set the number of bolts and spacing according to the schematic figure given.
Bolt properties: Bolt class, bolt diameter and hole properties are set in bolt properties.
Resources Tab
The source properties of the joints given in the schematic representation are set in the Resources tab. Give the thickness, type, angle values and mark the option whether to weld under construction site conditions.
Welding geometry is determined automatically by the program. These properties can be changed to easily determine the joint properties. Geometry features are in accordance with industry standards and in the form specified in AISC.
Welding Electrode:
In this section, the strengths of the welding electrodes are defined.
