Before drawing the railing, the railing types are selected and used from the library. You can also create your own railing types for the railing types not available in the library. The basic rationale of creating a new type of railing will be revealed by creating a typical railing step by step in the program.
| Table of Contents |
|---|
...
Creating Railing Type 1
...
There are 4 handrails of 2x2 cm and two railing profiles of 6x4 cm in the selected railing type. The steps to be followed to create the railing above are as follows;
...
Saving a Profile to the Archive
...
Create profiles in 2x2 cm and 6x4 cm dimensions and save them in the archive.
Resetting the Railing
Click theRailing Settings icon in the ribbon menu .
The Railing Settings dialog will open. Switch to the Railing Unit Settings Tab.
Click the Reset Railing button at the bottom of the dialog. This action will clear the dialog.
...
Usage step |
|---|
Clicking the reset railing button  |
Resetting the railing  |
Creating Railing Profiles
In the baluster profiles table, go to the first row named N = 1 and click the profile column.
Select the 4x6 cm sized profile that we previously defined and saved to the archive from the drop-down list.
In the baluster profile table, go to the second row named N = 2.
In the Distance column, type a value of 1.2, the distance between the two rails.
Click on the profile column and select the 4x6 cm profile from the list.
The second baluster will be formed. The image of the railing can be viewed on the right in the dialog.
Usage step |
|---|
Choosing the profile of N = 1 line as 4x6 cm  |
Writing 1,2 as the distance value for the line N = 2  |
Choosing the profile for the line N = 2 as 4x6 cm  |
Formation of balusters  |
Creating Handrail Profiles
To create the handrail profiles;
...
Click the OK button to exit the railing settings.
The railing command is active.
You can draw the railing you have created by clicking the points in the drawing area.
Creating Railing Type 2
Using the created railing to make the railing shown below:
...
Click the OK button to exit the railing settings.
The railing command is active.
You can draw the railing you have created by clicking the points in the drawing area.
Creating Railing Type 3
Making a railing with plates:
...