...
You can access it under the 3D Geometric Object title of the Ribbon menu, Facade tab .
...
Sweep Toolbar
...
Icons |
|---|
Sweep  Draws a continuous form object according to the selected section. |
Cartonpierre  Draws a cartonpierre object. |
Baseboard  Draws a baseboard object. |
Border on wall  Draws a border on the wall object. |
Cordon  Draws a cordon object. |
Roof gutter  Draws a gutter around the roof object. |
Dome gutter  Draws a gutter around the dome object. |
Free drawn  Draws the sweep freely by giving a point without being attached to any object. |
Path based  Draws a sweep based on the path object. |
Parent based  Draws asweep while adhering to the contour of an object like zone etc. |
Wall based  Draws the sweep attached to the wall. |
Story top aligned  It automatically adjusts the level of the sweep to be the same as the story ceiling level and draws the object at that level. |
Story bottom aligned  It automatically adjusts the level of the sweep to be the same as the story floor level and draws the object at that level. |
Story alignment free  It takes the elevation of the sweep as much as the given level and draws the object at that level. |
Sweep operations  Opens an auxiliary toolbar with commands for changing sweep. |
Section list  It is the list that allows the section of the sweep to be determined. A profile is selected from the list while drawing the object. |
Profiles  Displays the folder of profiles saved in the project or to disk and allows sweep. |
Settings  Displays the settings of the sweep. |
Usage Steps
Click the Sweep icon under the Facade tab, 3D Geometric Object title.
The free drawn mode in the toolbar for the sweep is automatically active.
In this mode, click the 1st, 2nd and consecutive points to draw the sweep.
Press the right mouse button to finish the command.
Usage step |
|---|
Determining the first point by clicking the left mouse button  |
Determination of the second point  |
Creation of the sweep   |
...
Next Topic