Sweep command creates object in continuous mode with a selected profile.
You can access it under the 3D Geometric Object title of the Ribbon menu, Facade tab .
Draws a continuous form object according to the selected section.
Draws a cartonpierre object.
Draws a baseboard object.
Border on wall
Draws a border on the wall object.
Draws a cordon object.
Draws a gutter around the roof object.
Draws a gutter around the dome object.
Draws the sweep freely by giving a point without being attached to any object.
Draws a sweep based on the path object.
Draws asweep while adhering to the contour of an object like zone etc.
Draws the sweep attached to the wall.
Story top aligned
It automatically adjusts the level of the sweep to be the same as the story ceiling level and draws the object at that level.
Story bottom aligned
It automatically adjusts the level of the sweep to be the same as the story floor level and draws the object at that level.
Story alignment free
It takes the elevation of the sweep as much as the given level and draws the object at that level.
Opens an auxiliary toolbar with commands for changing sweep.
It is the list that allows the section of the sweep to be determined. A profile is selected from the list while drawing the object.
Displays the folder of profiles saved in the project or to disk and allows sweep.
Displays the settings of the sweep.
Click the Sweep icon under the Facade tab, 3D Geometric Object title.
The free drawn mode in the toolbar for the sweep is automatically active.
In this mode, click the 1st, 2nd and consecutive points to draw the sweep.
Press the right mouse button to finish the command.
Determining the first point by clicking the left mouse button
Determination of the second point
Creation of the sweep