Steel Column Design Settings are explained in detail under this title.
Design Settings Sub-Tabs
After completing the steel column modeling
...
, double-click on the element to enter its properties.
...
Two new sub-tabs
...
, “Releases / Partial Fixity” and “Design,” appear in the steel column setting menu. These tabs contain adjustments for analysis and design.
Releases / Partial Fixity
In the Releases tab, end releases and spring values
...
can be entered at the starting and ending points of the element.
...
...
Override end releases This command is activated by defining user-defined end releases. | |
I-Release If the axial force for the starting point of the element 2-direction shear force, 3-direction shear force, torsion, 2-direction moment, and 3-direction moment are indicated, the corresponding force will be 0 at the starting point. | |
2 J-Release For the end point endpoint of the element, axial force, 2-direction shear force, 3-direction shear force, torsion, 2-direction moment, and 3-direction moment are indicated, and the corresponding force will be 0 at the starting end. | |
Spring values - I 3The spring coefficient is entered for the starting point of the element. Units can be changed by clicking the right button in the box. | 4 |
Spring Spring values - J The spring coefficient is entered for the end point endpoint of the element. Units can be changed by clicking the right button in the box. |
Design
The parameters used in the design are intervened in the Design tab. If a mark is placed in the box, the coefficient written in the box is used in the design. If no mark is placed in the box, ideCAD Structural automatically determines these coefficients and uses them in the design.
...
K Major
...
Effective length factor for major axis
...
K Minor
...
Effective length factor for minor axis
...
Unbraced length ratio (Major)
...
The ratio of the length between two elements connected to the element in its strong direction to the entire element length
...
Unbraced length ratio (Minor)
...
The ratio of the length between two elements connected in the weak direction to the entire element length
...
Laterally unbraced length ratio(LTB)
...
The ratio of the length between laterally unbraced length along either flange
...
The lateral-torsional buckling modification factor (Cb )
...
Lateral-torsional buckling modification factor for nonuniform moment
diagrams when both ends of the segment are braced. It’s determined according to AISC 360-16 F1-1.
...
After analysis and design, the design check window is given in the “Column design → Column details” section.
...
Next Topic