| Table of Contents |
|---|
Hole
...
Size and
...
Application
Maximum hole sizes for bolts are given in Table 13.8 of the steel code.
ideCAD automatically uses these values for structural steel connection calculations and drawings.
...
The maximum distance of the center of any bolt to the nearest edge cannot exceed 12 times the thickness of the part it connects and 150 mm.
This control is not done automatically in connection design reports. However, in the connections calculated and created in accordance with the plastic design philosophy (for example, single plate connections, double and single angle connections, etc.), the edge distance is 2 * d with the diameter of the bolt d and the distance between the bolts is maximum 8 . * d is generated.
Weld Thickness
...
Note: The points specified in ÇYTHE 2018 13.2.2.2 for the maximum thickness of the fillet welds are not automatically controlled.
...
Next Topic