The cartonpierre creates an object in the slab by default, with a selected profile.
Location of Cartonpierre Command
Click the Cartonpierre icon from the Sweep toolbar.
Sweep Toolbar
Icons |
|---|
Sweep  Draws a continuous form object according to the selected section. |
Cartonpierre  Draws a cartonpierre object. |
Baseboard  Draws a baseboard object. |
Border on wall  Draws a border on the wall object. |
Cordon  Draws a cordon object. |
Roof gutter  Draws a gutter around the roof object. |
Dome gutter  Draws a gutter around the dome object. |
Free drawn  Draws the sweep freely by giving a point without being attached to any object. |
Path based  Draws a sweep based on the path object. |
Parent based  Draws asweep while adhering to the contour of an object like zone etc. |
Story top aligned  It automatically adjusts the level of the sweep to be the same as the story ceiling level and draws the object at that level. |
Story alignment free  It takes the elevation of the sweep as much as the given level and draws the object at that level. |
Sweep operations  Opens an auxiliary toolbar with commands for changing sweep. |
Section list  It is the list that allows the section of the sweep to be determined. A profile is selected from the list while drawing the object. |
Profiles  Displays the folder of profiles saved in the project or to disk and allows sweep. |
Settings  Displays the settings of the sweep. |
Usage Steps
Click the Cartonpierre icon.
Parent Based and Story Top Aligned modes in the toolbar are automatically active.
If desired, one of the free drawn and path based drawing modes can be selected.
At the same time, the profiles to be used in the cartonpierre object are listed in the Section box.
If wanted, a different profile can be selected from the Section box.
Mouse over the slab and left click.
Cartonpierre will form under the slab.
Usage step |
|---|
Moving the mouse over the slab  |
Ceating cartonpierre by clicking the left mouse button   |