The project, which was prepared with ideCAD Architectural, was opened with ideCAD Structural. You can specify TDY conditions and the horizontal elastic design spectrum using the Analysis Settings Wizard. |
Click on the Analysis Settings command.
In the General tab, check the 2018 TDY option.
Click the 2018 TDY Wizard for Analysis Settings button.
Click the Earthquake Ground Motion Level-2.
Click ZB as the site class.
Click the OK button to cancel the selections made on the next pages.
Click on the select point from map button.
On the map that opens, click on the location where the structure will be applied.
Click the offline button.
The Design Spectrum is defined according to DD-2 and DD-3.
Click the arrow to go to the next page.
Select the building risk category as BRC=3.
Seismic design category will be determined as DTS=2 .
Click the arrow to go to the next page.
Click on Story settings.
After checking the story settings, press the OK button to close the dialog.
The building height class will be defined as BYS=8 .
Click the arrow to go to the next page.
Performance level, KH and evaluation/design procedure are determined as DGT.
Click the arrow to go to the next page.
Select Reinforced Concrete as the structural system.
Select the Beam-and-slab structures and waffle slab as the slab type.
Select the Semi rigid diaphragm as the diaphragm modelling type.
Select the ductility of structure to High.
Select the structural type A11 for X direction.
Select the structural type A11 for Y direction..
Click the save icon to apply the parameters to the project.
Click the OK button to close the analysis settings dialog.