Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 18 Next »

How does ideCAD determine story drifts and limitations according to ASCE 7-16?


  • For any column or wall in the earthquake direction, the story drifts expressing the displacement difference between two floors, ∆i, is automatically obtained by ASCE Section 12.8.6.

  • The condition given in 12.8.2 and the minimum equivalent lateral force condition defined in ASCE Section 12.9.1.4.2 are taken into account automatically.


Symbols

Cd = Deflection amplification factor in Table 12.2-1
δxe = Deflection at the location required by this section determined by an elastic analysis
Ie = Importance Factor
Δi = According to any column or wall earthquake, the relative displacement difference between two consecutive layers expressing reduced drift
δi = Story drifts


Story Drift Determination

The deflection at level x (δx) (in. or mm) used to compute the design story drift, Δ, is determined with the following equation.

Eq. (12.8-15) is used to estimate inelastic deflections (δx), which are then used to calculate design story drifts, Δ. These story drifts must be less than the allowable story drifts, Δa, of Table 12.12-1.

Scaling of Drifts

Where the combined response for the modal base shear (Vt) is less than CsW, and where Cs is determined by Eq. (12.8-6), drifts are multiplied by CsW ∕ Vt.

DRIFT AND DEFORMATION

Story Drift Limit

The drift, Δ, is calculated according to the procedures of Section 12.8.6. (Sections 12.9.2 and 16.1 give methods for calculating displacements for modal response spectrum and linear response history analysis procedures, respectively; the definition of Δ in Section 11.3 should be used).

The design story drift (Δ), as determined in Sections 12.8.6, 12.9.1, or 12.9.2, does not exceed the allowable story drift (Δa) obtained from Table 12.12-1 for any story.

Structure

Risk Category

I or II

III

IV

Structures, other than masonry shear wall structures, four stories or less above the base as defined in ASCE Section 11.2, with interior walls, partitions, ceilings, and exterior wall systems that have been designed to accommodate the story drifts

0.025hsxc

0.020hsx

0.015hsx

Masonry cantilever shear wall structures

0.010hsx

0.010hsx

0.010hsx

Other masonry shear wall structures

0.007hsx

0.007hsx

0.007hsx

All other structures

0.020hsx

0.015hsx

0.010hsx



  • No labels