Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

  • Beam required strengths are calculated automatically.

  • Beam design strengths are calculated automatically.


Notation

Ag = gross area of concrete section, in2
Av = area of shear reinforcement within spacing s, in.2
D = dead load
E = earthquake load
fc' = specified compressive strength of concrete, psi
fyt = specified yield strength of transverse reinforcement, psi
L = live load
Lr = roof live load
Mn = nominal flexural strength at section, in.-lb
Mu = factored moment at section, in.-lb
Pn = nominal axial compressive strength of member, lb
Pu = factored axial force; to be taken as positive for compression and negative for tension, lb
R = rain load
S = snow load
Tn = nominal torsional moment strength, in.-lb
Tu = factored torsional moment at section, in.-lb
U = strength of a member or cross section required to resist factored loads or related internal moments and forces in such combinations as stipulated in ACI 318-19
Vn = nominal shear strength, lb
Vu = factored shear force at section, lb
W = wind load
ϕ = strength reduction factor


Required Strength

Required strength is calculated in accordance with the factored load combinations in Load Factors and Combinations title.

According to ACI 9.4.2.1 and 9.4.3.1, for beams built integrally supports, Mu and Vu at the support can be be calculated at the face of support.

According to ACI 9.4.3.2, if all three conditions given below are satisfied, sections between the face of support and a critical section located d from the face of support for beams shall be permitted to be designed for Vu at that critical section.

  • Support reaction, in direction of applied shear, introduces compression into the end region of the beam

  • Loads are applied at or near the top surface of the beam

  • No concentrated load occurs between the face of support and critical section

According to ACI 9.4.4.3, sections between the face of support and a critical section located d from the face of support can be designed for Tu at that critical section except that there is a concentrated torsional moment within this distance.


Design Strength

Design strength at all sections should be satisfy all conditions given below;

  • ϕPn ≥ Pu

  • ϕMn ≥ Mu

  • ϕVn ≥ Vu

  • ϕTn ≥ Tu

Strength reduction factors ϕ is determined according to using ACI Table 21.2.2. Interaction between load effects is considered.

For cases with Pu< 0.10fc’Ag, axial forces are not effective in nominal flexural strength Mn. If Pu< 0.10fc’Ag, nominal flexural strength Mn with zero compression is calculated in accormance with Flexural Strength title. If Pu≥ 0.10fc’Ag, combined axial and flexural strength, Pn and Mn, are calculated in accordance with Axial strength or Combined Flexural and Axial Strength title.

Nominal shear strength, Vn, is calculated in accordance with One-Way Shear Strength title.

Nominal torsional moment strength, Tn, is calculated in accordance with Torsional Strength title.


  • No labels