Delta

With the delta command, the object is defined by holding it from different points during the object drawing phase of architectural and structural projects. Each time the delta command is run, the object node point changes and modeling is done by holding one of the bottom corner, middle or top corner points of the object. The delta command is used when drawing walls, beams, shears, and strips.

The delta can also be changed by pressing the spacebar on the keyboard.

Location of the Delta Command

You can access it from the wall toolbar.

Open

You can access it from the beam toolbar.

Open

You can access it from the shearwall toolbar.

You can always access it from the ODT door/window toolbar.

You can always access it from the strip footing toolbar.