/
Part 46. Fix the Failures
Part 46. Fix the Failures
In this tutorial, fix the failures.
This video contain the following:
1. Use the Analysis+Design (F9) command.
2. Open the Concrete All Failures list.
3. Use the Concrete Column-Beam Joint Area command.
4. Open the Column Settings.
5. Change the column dimensions.
6. Open the story 1 ceiling page.
7. Open the Column Settings.
8. Change the column dimensions.
9. Use the Analysis+Design (F9) command.
10. Open the Concrete All Failures list.
11. Use the Concrete Column-Beam Joint Area command.
, multiple selections available,
Related content
Fix the Failures
Fix the Failures
More like this
Part 51. Review Concrete Design
Part 51. Review Concrete Design
More like this
Review Concrete Design
Review Concrete Design
More like this
Part 44. Optimize the Structural System
Part 44. Optimize the Structural System
More like this
Examine the Structural Model
Examine the Structural Model
More like this
Insufficient Reinforcement in Column
Insufficient Reinforcement in Column
More like this