/
Vertical Static Loads
Vertical Static Loads
Dead Loads
Area distributed load on the story is applied as 0.5 kN/m2 in the basement stories, 4 kN/m2 in the roof floor and 1.5 kN/m 2 in all other stories.
Roof story loads can be seen in the image below.
Live Loads
Basement 5 kN/m2, on the top story 1 kN/m2 and all other stories 2 kN/m2 was applied load is spread over the story area as.
Live load reduction factor is determined as 0.3 according to Table 4.3 of TBDY 2018. ideCAD Structural story general settings are adjusted in HYK section. For detailed information, see: Mass Definition at Joints (4.5.9)
Next Topic
Related content
Determination of Equivalent Lateral Force Acting on Stories per ASCE 7-16 with ideCAD
Determination of Equivalent Lateral Force Acting on Stories per ASCE 7-16 with ideCAD
More like this
Vertical Distribution of Seismic Forces (4.7.2)
Vertical Distribution of Seismic Forces (4.7.2)
More like this
Story Parameters
Story Parameters
More like this
Static Linear Load Case
Static Linear Load Case
More like this
Second Order Effect Calculation and Control
Second Order Effect Calculation and Control
More like this
Limits of Story Dritfs
Limits of Story Dritfs
More like this